Hook up my car Installing a DIY Car Amplifier

Hook up my car

Rickenbacker 360 dating

Make sure you have 12 volts to hot wire and a good ground. Answer this question Flag as The RMS is the amount of power a speaker can continuously have sent to it without going bad.

Dating latino man

Thank you for the comment. For some cars, you may need to remove several pieces of plastic trim, usually working from the bottom up. Set the parking brake and disconnect the negative cable from your car battery.

Online dating how to tell if a guy likes you

Why does my amp keep blowing fuses even when it is hooked up correctly? You'll need to stay within 2—3 feet 0.

Jimin dating hayoung

Some stereo shops have huge spools of wire available by the foot. This amp has the following ratings when it is in "bridged mode".

Define radiopotassium dating

All text shared under a Creative Commons License. Use a capacitor to prevent voltage drops caused by deep bass hits, i.

Step 1: Parts

If you're using wiring harnesses, this connection will be made when you connect the harness pieces. Walmart sells amplifier kits as do some other stores. Some head units have a separate wire that must go to hook up my car for the display separately.

Dating in kolkata girl

Make sure you buy a dating campbell river box that has a hole the same size as your speaker. Car Radios and Sound Systems In other languages: The remote wire needs a 12v signal to turn on the amp.

The remote wire tells the amp to turn on. When the stereo is fully in, you should hear it click into place.

38 dating 23 year old

Not Helpful 1 Helpful 2. If it is a stock stereo on a car without a power antenna and no blue wire, then run the 16 - 18 gauge wire to the fuse box, and connect it to a fuse that turns on when the accessories are on.

Introduction: Installing Subwoofers in a Car

Bheki DuxF author Reply Car Radios and Sound Systems In other languages: KaptainK1 author adamk48 Reply Lightly sand the contact area to expose clean metal before attaching ground. Run the 12v power wire usually the longest wire in the kit, mostly red, typically ranges from 8 gauge to 0 gauge from the battery through the firewall and then to the amp. Connect the power cable from the battery into the spot on the amp that has one of the following markings do not connect it to the speaker positive: